方焦面上设置视场光阑,它到目镜第一面的距离称目镜的工作距离,不能太短。尤其在测量用显微镜中,此距离应保证近视眼观察时不能因目镜调焦而碰到分划板。由于物镜的高倍放大,目镜只承担很小的光束孔径角,但视场相对较大,因此显微镜目镜属短焦距的小孔径大视场系统,设计时首先应考虑轴外像差,主要是倍率色差、彗差和像散的校正。一、惠更斯目镜惠更斯目镜是观察用生物品微镜中普遍应用的目镜,由二块平面朝向眼睛的平凸透镜相隔一定距离组成,如下图1所示。朝向物镜的那块透镜叫场镜,朝向眼睛的那块透镜叫接目镜。场镜的作用是使由物镜射来的轴外光束折向接目镜,以减小接目镜的口径,也有利于轴外像差的校正。图1通常惠更斯目镜的二块透 ...
和缝扫描、宽视场轻片显微镜成像和多焦成像。这些方法通常达到比点扫描成像快20倍的采集速度,即使它们对活细胞成像不够快,但它们构成了拉曼光谱许多其他应用的合适替代品。在第二种策略中,通过使用不同的拉曼模式来增加拉曼信号的强度,这反过来允许更短的捕获时间。在脑生理病理研究中,与自发拉曼相比,常用三种模式来提高信号强度:非线性拉曼散射技术,如受激拉曼散射(SRS)和相干反斯托克斯拉曼散射(CARS),以及表面增强拉曼散射(SERS)。图1在拉曼散射的非线性模式中,使用多个激光刺激特定的振动跃迁,从而增加信号的强度。简单地说,在SRS中,样品用自发拉曼中的“泵浦”激光照射,并结合较低频率的“斯托克斯” ...
分割效果。宽视场照明和成像检测窄带滤波器可用于拉曼成像。第一个成功的现代仪器采用了干涉滤波器,它可以倾斜以改变通带。随后,声光可调谐滤波器(AOTF)和液晶可调谐滤波器(LCTF)被引入到拉曼成像中,并提供了电子可调谐性。可调滤波器方法已被证明是测量隔离波段最有用的方法。如果只需要几个帧来定义波段,全球拉曼成像可以相当快。当有许多重叠波段或非线性背景时,许多图像必须以不同的拉曼位移拍摄,时间优势就消失了。需要注意的是,声光滤波器的透射率仅为50%左右,而液晶滤波器的透射率约为20 - 40%。相比之下,电介质滤光片通过80-90%的入射光。这种差异是因为AOTF和LCTF都作用于线偏振光。在大 ...
畸变系统的一般像差理论(一)-费马原理和汉密尔顿的特征函数我们将像差函数写成幂级数展开形式,并表明在一个畸变系统中有16种主要的像差类型。我们还将证明畸变主波误差和光线误差之间的联系。本次主要介绍介绍费马原理和汉密尔顿的特征函数。费马原理是几何光学的基本定律之一,它指出:光线从点P传播到点P '必须穿过一条光程长度,该光程长度相对于路径的变化是静止的。根据费马原理,我们可以得出一个重要的结论:对于光学系统中任意两个非共轭点P和P ',都有且只有一条光线通过这两点。如果P和P '是共轭点,这个结论是无效的,因为所有穿过共轭点的光线都具有相同的光程长度。这一结论的理论重要性 ...
像系统的清晰视场为所成像中的一条线,根 据透镜焦距和成像倾角可以计算出成像变形量。通过二级成像原理弥补一级成像的缺陷,利用一级成像在空间上呈现样品实像,然后通过二级成像,在相机的感光芯片上成像。椭偏成像是相机经过光电转换,再进行A/D转换后形成的,图像传感器 中的电信号与接收的光强成正比,因此可以从采集的图像中获取样品的表面形貌和厚度分布。分析椭偏图像时要求原始成像图具有较好的成像质量,因此可以采用连续抓取时间积分法来提高图像的信噪比,以此改善图像的质量。通过采用多样点平均法来降低随机噪声对图像定量分析的影响,提高可靠性。如果您对椭偏仪有兴趣,请访问上海昊量光电的官方网页:https://ww ...
望远镜物镜的视场较小,例如大地测量仪器中的望远镜,视场仅 1~2度;天文望远镜的视场则是以分计的;而一般低倍率的观察用望远镜,视场也只在10 度以下。但物镜的焦距和相对孔径相对较大,这是为保证分辨率和主观亮度所必需的,可认为是长焦距、小视场中等孔径系统。因此,望远镜物镜只需对轴上点校正色差、球差和对近轴点校正彗差,轴外像差可不予考虑,其结构相对比较简单,一般有折射式望远镜物镜、反射式望远镜物镜、折反射式望远镜物镜,这篇文章主要介绍折射式望远镜物镜。这类物镜要达到上述像质要求并无困难,但要求高质量时,要同时校正二级光谱和色球差就相当不易。后者常只能以不同程度地减小相对孔径才能实现。这类物镜常用的 ...
需承担较大的视场,对轴外像差不利,难以达到预期的像质。而负一倍双组转像系统一般采用二个相同且对称设置的双胶合镜组,并在二镜组的中间位置放置光阑,如下图3所示,使镜筒长度增加了。在共轭距取定后,镜组的焦距和间隔的选择与像质有关。间隔大对校正像散有利,但会导致轴外光束渐晕的增加。一般不应使渐晕大于 50%。图3需要注意,如果只是简单地加入透镜转像系统,则轴外点成像光束在转像镜组上的入射高度将大为增加,以致视场较大时,绝大部分光线不能通过转像系统。为此,可在中间实像平面上加一适当光焦度的透镜,使望远镜的光瞳与转像系统的光疃共轭,使轴外光束折向转像镜组,如下图4所示。这种加于中间像面上或其附近的透镜称 ...
、样品损坏、视场、成本和易用性等标准对于广泛的适用性至关重要,这推动了人们对先jin材料和应用中磁性理解的未来发展。电子和x射线显微镜可以提供低至几纳米的高空间分辨率,但耗时,需要昂贵的复杂仪器,仔细的样品制备和高真空环境。磁力显微镜(MFM)通常用于表征磁性器件,但由于其侵入性磁尖,固有的速度很慢,不适合成像脆弱的磁化状态。另一方面,磁光克尔效应显微镜(MOKE)是一种非侵入性光学技术,在进一步了解自旋霍尔效应和zui近在环境条件下形成的磁性斯基米子气泡方面发挥了巨大作用。MOKE的主要限制是它适用于表现出强克尔响应的材料。有源MOKE层已应用于某些材料类型以诱导MOKE响应,然而这种侵入性 ...
免了焦深小、视场窄的问题,可实现高分辨率、宽视场测量,可用于对纳米薄膜几何参数的测量。2018年韩国朝鲜大学提出用于表征多层膜结构的大面积光谱成像椭偏仪,利用宽带光源和成像光谱仪,光谱范围可以达到400-800nm。准直光束通过扩束器扩展,直径达到30mm,通过低放大率成像透镜得到旋转补偿器旋转引起的偏振变化的光谱空间强度图像,该图像可以表征相对较大区域的薄膜厚度剖面,横向分辨率也已经达到4μm。至此,椭偏成像技术已经实现大视场、宽光谱成像,可以应用在更多方面。根据测量的要求,椭偏成像技术可以用作定性技术、准定量技术或完全定量技术。但是在进行完全定量测量时,需要更精确的校准、校正和计算。201 ...
样品包含整个视场的大面积区域内的测量信息,实时观测样品的状态,实现大视场宽光谱测量,在纳米薄膜、生物医学等方面具有极大的应用价值。如果您对椭偏仪相关产品有兴趣,请访问上海昊量光电的官方网页:https://www.auniontech.com/three-level-56.html相关文献:1薛利军, 李自田, 李长乐, 等 . 光谱成像仪 CCD 焦平 面组件非均匀性校正技术研究[J]. 光子学报, 2006, 35(5): 693-696.2游海洋, 贾建虎, 陈剑科, 等 . 面阵 CCD 探测的全自 动椭圆偏振光谱系统研究[J]. 红外与毫米波学报, 2003, 22(1): 45-5 ...
或 投递简历至: hr@auniontech.com